Direct electrosynthesis of 52% concentrated CO on silver’s twin boundary

¹

,

²

,

³

et al. 2023

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…For IW-Ag, the values are 78.81 μm –1 and 41.87% (Figures S8–S10), and for BW-Ag, the values are 57.18 μm –1 and 31.65% (Figures S11–S13). These results indicate that liquid nitrogen can increase the SFD significantly, and the SFD value in LN-Ag is much higher than what was reported in the literature ,,− (Table S2). In addition, the XPS and XRD patterns show that LN-Ag, IW-Ag, and BW-Ag only contain a pure silver phase (Figures g–h), and ablation media did not change the phase constitution of the products.…”

contrasting

confidence: 45%

Engineering Dense Stacking Faults in Silver Nanoparticles for Boosting the Oxygen Reduction Reaction

¹

,

²

,

³

et al. 2023

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…For IW-Ag, the values are 78.81 μm –1 and 41.87% (Figures S8–S10), and for BW-Ag, the values are 57.18 μm –1 and 31.65% (Figures S11–S13). These results indicate that liquid nitrogen can increase the SFD significantly, and the SFD value in LN-Ag is much higher than what was reported in the literature ,,− (Table S2). In addition, the XPS and XRD patterns show that LN-Ag, IW-Ag, and BW-Ag only contain a pure silver phase (Figures g–h), and ablation media did not change the phase constitution of the products.…”

contrasting

confidence: 45%

ACS Appl. Energy Mater.

Electrocatalytic Hydrogen Production and Synergistic Formaldehyde Degradation

Hao

¹

,

Zhang²,

Teng

³

et al. 2023

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…The reason for this phenomenon may be that an excessive amount of formaldehyde may be difficult to desorb from the surface of the catalyst. 43 In addition, the chronoamperometric test shows that with an increase in formaldehyde concentration, a similar current density is maintained after running for 2 h (Figure 9a). Moreover, Figure 9b shows that at 2, 5, 10, and 20 mg L −1 of formaldehyde, 1.1, 2.4, 3.6, and 5.9 mg L −1 of formaldehyde were degraded after 2 h, respectively.…”

Section: Oer and Her Performances

mentioning

confidence: 84%

“…Among them, the cell voltage is the lowest at 2 mg L –1 of formaldehyde. The reason for this phenomenon may be that an excessive amount of formaldehyde may be difficult to desorb from the surface of the catalyst . In addition, the chronoamperometric test shows that with an increase in formaldehyde concentration, a similar current density is maintained after running for 2 h (Figure a).…”

Section: Results

mentioning

confidence: 99%

Highly selective photoelectrochemical CO ₂ reduction by crystal phase-modulated nanocrystals without parasitic absorption

¹

,

Liu

²

,

Proc. Natl. Acad. Sci. U.S.A.

³

et al. 2024

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…The current density was vastly improved in the CO 2 -saturated solution ( Fig. 4 A ), indicating that CO 2 can be efficiently converted on the phase-Ag catalyst ( 54 ). The gas and liquid products were further analyzed by gas chromatography and NMR spectroscopy.…”

Section: Results

mentioning

confidence: 99%

Engineering Dense Stacking Faults in Silver Nanoparticles for Boosting the Oxygen Reduction Reaction

¹

,

²

,

³

et al. 2023

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…For IW-Ag, the values are 78.81 μm –1 and 41.87% (Figures S8–S10), and for BW-Ag, the values are 57.18 μm –1 and 31.65% (Figures S11–S13). These results indicate that liquid nitrogen can increase the SFD significantly, and the SFD value in LN-Ag is much higher than what was reported in the literature ,,− (Table S2). In addition, the XPS and XRD patterns show that LN-Ag, IW-Ag, and BW-Ag only contain a pure silver phase (Figures g–h), and ablation media did not change the phase constitution of the products.…”

contrasting

confidence: 45%

ACS Appl. Energy Mater.

Electrocatalytic Hydrogen Production and Synergistic Formaldehyde Degradation

Hao

¹

,

Zhang²,

Teng

³

et al. 2023

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…The reason for this phenomenon may be that an excessive amount of formaldehyde may be difficult to desorb from the surface of the catalyst. 43 In addition, the chronoamperometric test shows that with an increase in formaldehyde concentration, a similar current density is maintained after running for 2 h (Figure 9a). Moreover, Figure 9b shows that at 2, 5, 10, and 20 mg L −1 of formaldehyde, 1.1, 2.4, 3.6, and 5.9 mg L −1 of formaldehyde were degraded after 2 h, respectively.…”

Section: Oer and Her Performances

mentioning

confidence: 84%

“…Among them, the cell voltage is the lowest at 2 mg L –1 of formaldehyde. The reason for this phenomenon may be that an excessive amount of formaldehyde may be difficult to desorb from the surface of the catalyst . In addition, the chronoamperometric test shows that with an increase in formaldehyde concentration, a similar current density is maintained after running for 2 h (Figure a).…”

Section: Results

mentioning

confidence: 99%

Highly selective photoelectrochemical CO ₂ reduction by crystal phase-modulated nanocrystals without parasitic absorption

¹

,

Liu

²

,

Proc. Natl. Acad. Sci. U.S.A.

³

et al. 2024

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…The current density was vastly improved in the CO 2 -saturated solution ( Fig. 4 A ), indicating that CO 2 can be efficiently converted on the phase-Ag catalyst ( 54 ). The gas and liquid products were further analyzed by gas chromatography and NMR spectroscopy.…”

Section: Results

mentioning

confidence: 99%

Engineering Dense Stacking Faults in Silver Nanoparticles for Boosting the Oxygen Reduction Reaction

¹

,

²

,

³

et al. 2023

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…For IW-Ag, the values are 78.81 μm –1 and 41.87% (Figures S8–S10), and for BW-Ag, the values are 57.18 μm –1 and 31.65% (Figures S11–S13). These results indicate that liquid nitrogen can increase the SFD significantly, and the SFD value in LN-Ag is much higher than what was reported in the literature ,,− (Table S2). In addition, the XPS and XRD patterns show that LN-Ag, IW-Ag, and BW-Ag only contain a pure silver phase (Figures g–h), and ablation media did not change the phase constitution of the products.…”

contrasting

confidence: 45%

ACS Appl. Energy Mater.

Electrocatalytic Hydrogen Production and Synergistic Formaldehyde Degradation

Hao

¹

,

Zhang²,

Teng

³

et al. 2023

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…The reason for this phenomenon may be that an excessive amount of formaldehyde may be difficult to desorb from the surface of the catalyst. 43 In addition, the chronoamperometric test shows that with an increase in formaldehyde concentration, a similar current density is maintained after running for 2 h (Figure 9a). Moreover, Figure 9b shows that at 2, 5, 10, and 20 mg L −1 of formaldehyde, 1.1, 2.4, 3.6, and 5.9 mg L −1 of formaldehyde were degraded after 2 h, respectively.…”

Section: Oer and Her Performances

mentioning

confidence: 84%

“…Among them, the cell voltage is the lowest at 2 mg L –1 of formaldehyde. The reason for this phenomenon may be that an excessive amount of formaldehyde may be difficult to desorb from the surface of the catalyst . In addition, the chronoamperometric test shows that with an increase in formaldehyde concentration, a similar current density is maintained after running for 2 h (Figure a).…”

Section: Results

mentioning

confidence: 99%

Highly selective photoelectrochemical CO ₂ reduction by crystal phase-modulated nanocrystals without parasitic absorption

¹

,

Liu

²

,

Proc. Natl. Acad. Sci. U.S.A.

³

et al. 2024

Abstract

Smart CitationsHow this paper cites the one you are viewing

“…The current density was vastly improved in the CO 2 -saturated solution ( Fig. 4 A ), indicating that CO 2 can be efficiently converted on the phase-Ag catalyst ( 54 ). The gas and liquid products were further analyzed by gas chromatography and NMR spectroscopy.…”

Section: Results

mentioning

confidence: 99%