Network Working Group                                  V. Kalusivalingam
Request for Comments: 4075         Cisco Systems (India) Private Limited
Category: Standards Track                                       May 2005

Simple Network Time Protocol (SNTP) Configuration Option for DHCPv6

Status of This Memo

This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited.

Copyright Notice

Copyright (C) The Internet Society (2005).

Abstract

This document describes a new DHCPv6 option for passing a list of Simple Network Time Protocol (SNTP) server addresses to a client.

1.  Introduction

This document describes a new option, called the SNTP [3] servers option, for passing information about SNTP servers in DHCPv6 [1].

2.  Requirements

The keywords MUST, MUST NOT, REQUIRED, SHALL, SHALL NOT, SHOULD, SHOULD NOT, RECOMMENDED, MAY, and OPTIONAL, when they appear in this document, are to be interpreted as described in RFC 2119 [2].

3.  Terminology

This document uses terminology specific to IPv6 and DHCPv6 as defined in the "Terminology" section of the DHCPv6 specification [1].

4.  Simple Network Time Protocol (SNTP) Servers Option

The Simple Network Time Protocol servers option provides a list of one or more IPv6 addresses of SNTP [3] servers available to the client for synchronization. The clients use these SNTP servers to synchronize their system time to that of the standard time servers. Clients MUST treat the list of SNTP servers as an ordered list. The server MAY list the SNTP servers in decreasing order of preference. The option defined in this document can only be used to configure information about SNTP servers that can be reached using IPv6. The DHCP option to configure information about IPv4 SNTP servers can be found in RFC 2132 [4]. Mechanisms for configuring IPv4/IPv6 dual- stack applications are being considered, but are not specified in this document.

Kalusivalingam              Standards Track                     [Page 1]


RFC 4075          SNTP Configuration Option for DHCPv6          May 2005

The format of the Simple Network Time Protocol servers option is as shown below:

0 1 2 3

       0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |      OPTION_SNTP_SERVERS       |        option-len            |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                                                               |
      |                  SNTP server (IPv6 address)                   |
      |                                                               |
      |                                                               |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                                                               |
      |                  SNTP server (IPv6 address)                   |
      |                                                               |
      |                                                               |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                              ...                              |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

option-code: OPTION_SNTP_SERVERS (31)

option-len: Length of the 'SNTP server' fields, in octets;
it must be a multiple of 16

SNTP server: IPv6 address of SNTP server

5.  Appearance of This Option

The SNTP servers option MUST NOT appear in messages other than the following: Solicit, Advertise, Request, Renew, Rebind, Information- Request, and Reply. If this option appears in messages other than those specified above, the receiver SHOULD ignore it.

The option number for this option MAY appear in the Option Request Option [1] in the following messages: Solicit, Request, Renew, Rebind, Information-Request, and Reconfigure. If this option number appears in the Option Request Option in messages other than those specified above, the receiver SHOULD ignore it.

Kalusivalingam              Standards Track                     [Page 2]


RFC 4075          SNTP Configuration Option for DHCPv6          May 2005
6.  Security Considerations

The SNTP servers option may be used by an intruder DHCPv6 server to cause DHCPv6 clients to contact a rogue SNTP server, resulting in invalid synchronization of time in the client, finally leading to time-critical applications running inaccurately in the client machine. Time accuracy can be crucial to some security algorithms. For example, expired certificates may gain a new life, making the applications running on the client machine less secure. The inaccuracy can even cause clients to set their time incorrectly, making them vulnerable to replay attacks in protocols that use time stamps to detect replays.

To avoid attacks through these options, the DHCPv6 client SHOULD use authenticated DHCPv6 (see the "Authentication of DHCP messages" section in the DHCPv6 specification [1]).

7.  IANA Considerations

The IANA has assigned an option code to the following from the option-code space defined in the "DHCPv6 Options" section of the DHCPv6 specification [1].

Option Name Value Described in OPTION_SNTP_SERVERS 31 Section 4.

8.  Acknowledgements

Thanks to the DHC Working Group for their time and input on the specification. In particular, thanks to (in alphabetical order) Bernie Volz, Jim Bound, Margaret Wasserman, Pekka Savola, Ralph Droms, Robert Elz, and Thomas Narten for their thorough review.

Kalusivalingam              Standards Track                     [Page 3]


RFC 4075          SNTP Configuration Option for DHCPv6          May 2005
9.  Normative References

[1] Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M.
Carney, "Dynamic Host Configuration Protocol for IPv6 (DHCPv6)", RFC 3315, July 2003.

[2] Bradner, S., "Key words for use in RFCs to Indicate Requirement
Levels", BCP 14, RFC 2119, March 1997.

10.  Informative References

[3] Mills, D., "Simple Network Time Protocol (SNTP) Version 4 for
IPv4, IPv6 and OSI", RFC 2030, October 1996.

[4] Alexander, S. and R. Droms, "DHCP Options and BOOTP Vendor
Extensions", RFC 2132, March 1997.

Author's Address

Vijayabhaskar A. Kalusivalingam Cisco Systems (India) Private Limited, No: 9, Brunton Road, Bangalore - 560025 India

Phone: +91-80-51036615 EMail: vibhaska@cisco.com

Kalusivalingam              Standards Track                     [Page 4]


RFC 4075          SNTP Configuration Option for DHCPv6          May 2005

Full Copyright Statement

Copyright (C) The Internet Society (2005).

This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights.

This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79.

Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at http://www.ietf.org/ipr.

The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf- ipr@ietf.org.

Acknowledgement

Funding for the RFC Editor function is currently provided by the Internet Society.

Translate documents to 日本語, svenska, Nederlands, Deutsch, français, русский, italiano, español, Tiếng Việt, polski, português, 中文, українська, català, norsk, فارسی, suomi, Bahasa Indonesia, العربية, čeština, 한국어, Bahasa Melayu, magyar, română, српски and other languages.